What to use for spray Stone Garden Decor?

Color coated with resin varnish. So if it is a rough Stone Garden Decor product without a gel coat layer, it can be simply treated with putty. It is recommended to spray the Stone Garden Decor with resin paint.

Although the varnish is slightly thin, if you are serious, you can apply it twice or use a slightly thicker floor paint. First, the gel coat is not easy to purchase for us. Second, the gel coat will not be bright when sprayed on the surface and will stick to your hands. The prerequisite is that the surface must be roughened, and all the exterior latex paint sprayed previously must be rubbed off. This latex paint and Stone Garden Decor must not be bonded.
The characteristics of stone carving models are heat resistance, low price, small thermal conductivity and good copyability. Generally used to make master molds. It is easy to manufacture and suitable for large-scale products. But it is not durable, is afraid of impact, and dries slowly. It is mostly used for single products and products with complex linear shapes, such as reliefs, etc. The stone sculpture used are mostly semi-water stone sculpture, that is, cooked stone sculpture. Just like cement molds, bricks and wood can be used as the skeleton foundation, and then covered with stone sculpture for modeling. In order to improve the stiffness and prevent cracks, sufficient fillers can be added to the stone sculpture, such as quartz, which can reduce shrinkage and cracks, and cement (stone sculpture: cement = 7:3) to increase strength. Some people have also proposed adding an appropriate amount of latex to stone sculpture and diluting it with water to make molds, which have good strength and no powder. Stone Carving molds can be used as master molds for low melting point alloy molds to cast alloys in a hot state. When using a stone carving master mold to make a stone carving mold (sub-mold), the surface of the master mold should be coated with a separating agent, such as potassium soap solution, transformer oil, edible oil, 20% stearic acid + 80% kerosene, or gasoline + petroleum jelly, etc. . The stone carving mold can be repaired by dipping a water pen into the stone carving. The stone carving mold drying process is: (60~120)℃/(4~5)L. After natural cooling, lightly polish with metallographic sandpaper, and then bake at (100~150)℃/(8~10)L, ( 200~230)℃/(20~24)L.