What are the technical difficulties in the operation of Stone Garden Statues

Let the Stone Garden Statues Factory introduce it to you!

1. Cutting: The cutting of stainless steel mainly depends on the plasma machine, and the required sample size only needs to be cut according to the cow felt sample selected when cutting the carbon steel plate.
2. Welding: When sealing the stainless steel plate, the shape of the stainless steel plate must be forged in place according to the requirements of the model (that is, the work level of what we usually call a sheet metal worker should be high). In order to prevent deformation of the stainless steel plate caused by uneven temperature during welding, it is often used to weld several points first and gradually weld to the periphery.
The quality of welding must be high, and the welding rod or wire selected by Stone Garden Statues Factory must be consistent with the stainless steel plate, otherwise the color of the welded and polished stainless steel will have color difference, which will affect the artistic effect of the surface (note: if the surface is attached to copper plate, oxygen welding should be used when welding) . Be sure to check to see if there are pores and trachoma. If the welding is not airtight and it stands outdoors, rainwater will easily seep into the stainless steel gap, and yellow rust water will flow out through the carbon steel plate, which will affect the surface effect and quality of the stone carving.
3. Surface treatment: After the stainless steel plate is closed, there may be unevenness, and there may be partial pockets. The method of correction can be cut off by a plasma machine, re-welded, and adjusted to flatness. For the sunken place, use a puller (tool) to pull it out and grind it flat. At the same time, use a belt machine to process the weld, and use a polishing machine to polish it until the uniform effect position required by the Stone Carving surface is thrown out.