Introduction to making stone crafts

stone crafts have a variety of shapes, such as geometric stone sculpture, round carvings, abstractions, etc., which are rich in content and strong in plasticity. Generally, the welding is relatively firm, that is, the skeleton of the stone carving itself is welded with the embedded iron on the base, and the steel bars are welded under the embedded iron, depending on the size of the Stone Carving. Determine the length of the reinforcement and the size of the embedded iron. For the sake of beauty, usually, after the stone carving is installed, the base will be pasted with iron marble or granite slabs. Let me tell you about the process of making stone crafts.

1. Surface treatment, the color of the stone crafts itself is silvery white with luster. Different colors can also be applied to the stone sculpture according to requirements, usually steam-baked paint.
2. Application: This product is suitable for indoor and outdoor places such as campuses, parks, gardens, residential areas, squares, shopping malls, hotels, guesthouses, and guild halls.
3. The advantages of stainless steel material, not easy to rust, easy to clean, and strong wind resistance, durable, become the mainstream of modern stone art!
4. It is cutting material. Generally, the tool used is electric scissors, which can cut thin plates below 2mm, but the flatness is not good after cutting. There is also a cutting machine, which can cut both thick and thin plates, but it can only cut straight lines, and there is nothing to do when encountering arcs. If you want to cut the stainless steel sheet into flat and various shapes, you need to use a plasma cutting machine. Plasma cutting machine can use high plasma to cut. It is difficult to cut metals with ordinary oxygen cutting. Because the current and gas are fed into the special water-cooled nozzle, a strong compression arc is formed to form a high temperature, above 10,000 degrees, and a plasma flow, so the cut stainless steel sheet is neat and does not deform. Note that the hand must be steady when cutting the material, otherwise the material will be cut. After the material is cut, it must be planed according to the shape required by the work. Don't leave hard wounds on the surface of the board, so as not to leave defects after the work is polished.
5. It is a method of making carbon steel plate stone sculpture and stainless steel plate stone sculpture. Carbon steel plates and stainless steel plates are not knocked on the mold, but are exported according to the different shapes of each part of the plaster model, and knocked consciously according to the ups and downs of the plaster model. It can be knocked on any solid object, and then take the knocked stainless steel plate to the mold for comparison. If it is considered that the shape is correct, it can be completely closed with the model, and then these scattered carbon steel plates, stainless steel plates, etc. The boards are welded piece by piece from top to bottom, and each piece must be adjusted against the mold. The surface texture effect of each stainless steel plate must remain the same, which must be forged while making the shape. You can also do the forging first and then cut the material. When forging points, use the round head of the hammer to forge evenly and regularly in rows. The width and distance, and the force should be the same. Do not hit randomly, otherwise it will destroy the overall sense of the stone carving.