About the cleaning and maintenance of Stone Garden Statues

Stone Garden Statues are common urban stone sculpture. stone carving materials are resistant to corrosion by weakly corrosive media such as air, steam, and water, as well as chemically corrosive media such as acids, alkali, and salts. Because Stone Garden Statues have many advantages, many Stone Carving materials are used as materials.

1. Water and cloth
Daily cleaning can be done by using warm water and a cloth. If you only use detergent and a rag to scrub the stone basins used at home, some stubborn dirt cannot be completely removed. If you use a steel wool brush, it will leave ugly scratches. At this time, just take some remaining radish or cucumber stalks, dip them in detergent and scrub them, then rinse them with water and they will be clean. In most cases, the surface will need to be dried with a towel or cloth after cleaning to prevent water spots. This is very important because the minerals in the water will leave marks on the stone.
2. Mild detergent and cloth
You can use neutral detergent and warm water to clean, which will not damage the stone carving. Mild neutral detergent can clean tough dirt very clean, and you can also use neutral detergent to wipe dirty areas. When you have finished cleaning and removing dirt, be sure to rinse the surface thoroughly to prevent detergent residue from staining the surface again or causing spots. Naturally derived cleaning agents are biodegradable and lose their presence when exposed to water, including some oils. This is the best method to use if you are cleaning stoneware pots or tableware. Food on delicatessen can usually be removed by soaking the pan in soapy water, preferably using a sponge pad with a mild detergent, as with steel wool it may scratch the stonework or leave particles behind, which may then cause rust, so be sure to Remember to rinse and dry the stonework.
3. Glass cleaner
Fingerprints on the surface of stone sculpture are probably the most troublesome thing. You can use glass cleaner to clean them. You can use a microfiber cloth and spray it with cleaner. You can also spray it directly on the stonework, but you may end up dripping, or you won't need to waste a lot of cleaner. Gently wipe the stonework area in a circular motion to eliminate fingerprints. Repeat as needed, then rinse thoroughly and towel dry.
4. Stone carving cleaning agent
If unfortunately the stone sculpture are rusty or have serious oil stains and other impurities on the surface, and you need to polish the stone sculpture, a stone carving cleaning agent may be a good choice. This stone carving cleaner (stone carving polish cleaner) can help reduce scratches and remove stains. It can also restore the bright surface of stone sculpture very well. After cleaning, be sure to rinse the surface thoroughly and tumble dry or towel dry.